Sirrix® ANTOX liquid

The new chelating dispersant can be widely used in the continuous treatment of cotton and linen fabrics to prevent catalytic damage and the oxidation of cellulose, and also helps to improve the whiteness of the fabrics.

• Remove iron ion contaminants from cotton

• Prevent catalytic damage and holes caused by iron

• Remove calcium and magnesium contaminants from cotton

• Significantly improve the whiteness of cotton fiber fabrics after oxygen bleaching

• Prevent insoluble calcium soap precipitates and other deposits from accumulating in equipment such as steam boxes and washing tanks

• Has high dispersing performance and can also avoid the formation of precipitates of insoluble salts in the bleaching solution

• Has good compatibility with α-amylase delignifying enzyme products

• No foam 

1. Performance

Appearance: Yellow to deep amber liquid

Chemical structure: Phosphate derivative

Specific gravity (20℃): 1.3 g/cm³

Ionic nature: Anionic

Solubility: Can be dissolved in cold water in any proportion

pH value: 6.0 ± 0.5

Storage stability: Can be stored for 12 months at 0 - 50℃

Working solution stability

• Hard water: Good

• Acid: Good

• Alkali: Excellent (above 36°Bé NaOH)

Processing temperature: 5 - 140℃ (high-temperature stability)

Compatibility

• Wetting agent/soaking agent: Good

• Enzyme: Good

• Stabilizer: Good

• Reducing agent: Good

• Oxidizing agent (hydrogen peroxide): Good

Foam: No foam

Toxicity, environmental protection data: Refer to the safety data sheet

2. Action form

Sirrix ANTOX.CN solution can be used in every step of cotton pre-treatment, not only in desizing and oxygen bleaching, but also in cooking and mercerization. Due to its outstanding chelating ability, it can chelate iron ions, thereby eliminating the catalytic damage that iron may cause to the fabric. With

It can also chelate Ca2+ and Mg2+.

It can also act on natural dyes, thereby significantly improving the whiteness of the fabric after oxygen bleaching. This avoids the need for additional reduction bleaching or oxidation bleaching. 

3 Application Scope: : : :

Removal of Starch

Cold Rolling Stack Starch Removal Process 4-6ml/l Hostapal XTRA liq. conc.

1-2ml/l Bactosol PHC liq. hc.

2-4ml/l Sirrix ANTOX.CN liq

Infiltrate the working solution at 20-80°C, and stack at room temperature for 6-12 hours.

Warping - Wringing - Steam Bleaching Process 4-6ml/l Hostapal UH.CN liq.

1-2ml/l Bactosol PHC liq. hc.

2-4ml/l Sirrix ANTOX.CN liq

Washing solution immersion treatment, steam sterilization at 100°C for 1-3 minutes

Enzymatic rapid desizing process 1-2ml/l Hostapal XTRA liq conc.

1-2ml/l Bactosol PHC liq highconc

2-4ml/l Sirrix ANTOX.CN liq

Washing tank: treated at 95°C for several seconds

Oxygen bleaching

Rolling - rolling - rolling - oxygen bleaching process 2-4ml/l Hostapal UH.CN liq

2-6ml/l Stabilizer FCB.CN liq.conc.

10 - 30 ml/l NaOH (48°Bé) 10-30ml/l H

2O2 (50%)

1-4ml/l Sirrix ANTOX.CN liq

Immersion bath working solution, steam sterilization at 100°C for 10-20 minutes

Cold rolling pile oxygen bleaching process 4-6ml/l Hostapal XTRA liq conc.

4-6ml/l Stabilizer FCB.CN liq.conc.

20 - 40 ml/l of NaOH (48°Bé) 30-60ml/l H

2O2 (50%)

1-4ml/l Sirrix ANTOX.CN liq

Left at room temperature for 12 to 24 hours 

Extraction (rolling-vaporization process)

20 - 80 ml/l NaOH (48°Bé) 2-4ml/l Hostapal UH.CN liq

1-2ml/l Sirrix ANTOX.CN liq

Wet spinning working solution, steam at 100°C for 1-10 minutes

Texturizing

26-30°Bé NaOH 1-2ml/l Sirrix ANTOX.CN liq

Discontinuous process

It can also be applied in the non-continuous pre-treatment processing of cotton (desizing, cooking, bleaching) and J-shaped, overflow and other equipment.

Recommended dosage: Sirrix ANTOX.CN liq 0.5-1ml/l

Many dyes, pigments and chemicals are patented by Clariant or its affiliated enterprises in most industries.

® indicates that the name has been registered by Clariant Limited or Clariant Germany Company in most cases.

* indicates that the trademark has been licensed to Clariant Limited for most uses.

+ Manufacturer's registered trademark

The symbols Ò, *, + are only marked when mentioned first.

The formulas and recommended processes provided in this document are based on our understanding and knowledge of the product and are for reference only. They cannot guarantee feasibility for all processes. Users must conduct preliminary tests and adjustments based on specific application conditions.