Imerol* FLOW liquid

A truly effective and APEO-free three-in-one additive, suitable for hydrogen peroxide bleaching processes of cotton and cotton-blended fabrics.

Its mechanism of action integrates refining, stabilization, and smoothness properties, ensuring the smoothness of the fabric during bleaching and subsequent dyeing processes.

• A reliable general-purpose product

• High whiteness even at low dosages

• Good penetration and cleaning performance

• Anti-warp and crease prevention

• Low foam

Imerol FLOW liquid is truly superior to previous three-in-one products used in hydrogen peroxide bleaching processes, offering great advantages that make the oxygen bleaching process efficient, environmentally friendly, and economical. 

1. Performance

Appearance: Yellow, slightly thick, clear or slightly cloudy liquid

Chemical structure: A mixed product of anionic and nonionic substances

Density (at 20℃): 1.0 g/cm³ 3

Ionic nature  -  Anions / Non-ions

Solubility  - Miscible with water in any ratio

pH value (1% solution)  - 5 - 6

Storage stability  - Good at 0 - 50℃, mixing evenly after thawing does not affect the quality Use

Solution stability

• Hard water     Good

• Acid/Alkali     Good Compatibility

• Wetting agent / detergent  Very good

• Stabilizer  Very good

• Oxidizer (H2O2)  Very good

Foam performance  Minimal foam

Environmental toxicity data  Refer to the safety data sheet. 

2. Working Principle

Due to the outstanding performance of Imerol FLOW liquid, it is applicable to various types of fibers in mechanical devices that cause friction marks and knotting problems.

Its unique application performance integrates excellent penetration, cleaning, and stability properties, meeting the requirements of rational and economic processes.

3. Application Scope

Non-continuous process

0.5 - 2.0% Imerol FLOW liq

Can be applied to rope-like, spray overflow, and other cyclic dyeing machines

Examples of application: : :

Oxygen bleaching (bath ratio: 8:1 - 10:1**)

0.3 - 1% Imerol FLOW Liq

3 - 4ml/l Sodium hydroxide (50%) 3 - 4ml/l    H

2O2 (50%)

Add the additive at 40℃, then raise the temperature at a rate of 2 - 4℃/min to 98℃. Boil for 45 minutes or heat at 110℃ for 15 minutes. Cool to 70℃ and drain the liquid. Rinsing

Rinsing with 80℃ warm water for 10 - 20 minutes, then draining

Rinsing with cold water mixed with 0.2 - 0.5ml/l Sirrix NE solution, then draining

Enzyme treatment to remove residual hydrogen peroxide:

0.01 - 0.1ml/l Enzyme ARL IP solution is treated at 30 - 40℃ and pH 6 - 8.5 for 10 - 20 minutes. No drainage is required and it can be directly stained. Color.

** When the bath ratio is very low

Many of the dyes, pigments and chemicals are patented by Clariant or its affiliated companies in most industries.

 indicates that the name has been registered by Clariant Limited or Clariant Germany in most cases.

* indicates that the trademark has been licensed to Clariant Limited for most uses.

+ indicates a manufacturer's registered trademark

The symbols Ò, *, + are only indicated when mentioned earlier.

The formulas and recommended processes provided in this document are based on our understanding and knowledge of the products and are for reference only. They cannot guarantee feasibility for all processes. Users must conduct preliminary tests and adjustments based on specific T

application conditions.